w w w . a r g o n a u d i o . c o m 3
SUB10
Running-in period
We recommend a running-in time of your new SUB10
Subwoofer of approximately 15-20 hours at normal listening
level before you decide on the final positioning and control
settings of the Subwoofer. During the running-in time the
drive units will settle in and perform as intended.
Connecting your Subwoofer
We recommend that you read the manual of your Amplifier
or AV-receiver carefully before connecting your Subwoofer.
First switch off the Amplifier and all equipment before you
connect the Subwoofer.
If your Amplifier/av-reciever has a SUB-OUT or PRE-OUT
function: Connect the Subwoofer input IN (10) as shown on
page 5 and your Amplifiers/av-recievers SUB-OUT or PRE-
OUT with a RCA/phono cable.
If your Amplifier does NOT have a SUB-OUT or PRE-OUT
function:
Connect the speaker cables from the Amplifier to the
Subwoofer (9) left/right, +/- as shown on page 5. Then
connect the satellite speakers to the Subwoofer using (8)
left/right, +/- as shown on page 5.
When finished connect the subwoofer net cable (6) as
shown on page 5 to the mains voltage, and push the
POWER ON/OFF button (5) as shown on page 5 to ON
position, the indicator lamp POWER LED will now glow blue
and the Subwoofer is active and ready to be used.
The Argon SUB10 Subwoofer has a built-in AUTO
STANDBY function and after approximately 10 minutes
without any input signal the subwoofer will automatically
switch off, and the indicator lamp POWER LED will change
color. When an input signal is detected the subwoofer will
become active and the indicator lamp POWER LED will
glow blue.
Setting volume, frequency and phase
The volume, crossover and phase (controls 1, 2 and 3 on
page 4-5 ) can be adjusted on the rear panel, and we
recommend that you adjust the setting of these controls to
your liking – try with different music and films. If you want
more detailed information on these control functions, we
invite you to visit our homepage www.argonaudio.com.
Care and cleaning
We don’t recommend use of any solvents or cleaners on
Argon SUB10 cabinet, the cabinet surface usually only
requires dusting or cleaning with a damp soft cloth
(only use cold clean water).
The grille fabric may be cleaned with a normal clothes brush
or vacuumed carefully with the grille detached from the
cabinet. Avoid touching the drive unit, and do not use the
Subwoofer as a coffee or drinks table (risk of water being
spilled into the subwoofer).
Disconnect the Subwoofer from the mains supply if taken
out of use for a longer period.
