w w w . a r g o n a u d i o . c o m
5
R a d i o 1
3. Using Your Argon RADIO1 radio
3.1 Quick start
3.1.1 Start up
1. Extend the Antenna
2. Plug the Power supply into an electric outlet and into the back of the Radio.
3. Press “
Power
” (9) on
4. The Radio will start searching for DAB stations automatically. This may take a few minutes
and the progress will be shown in the display.
5. Once finished searching, the Radio will start playing the first found station.
3.1.2 Basic Operating
1. Stations can be chosen by turning the “
Tuning/Select
” (3) knob/button.
2. Once the prefer station is found press the “
Tuning/Select
” (3) knob/button and the chosen
station will start playing.
3. To store a station on one of the 1-6 preset buttons, press and hold the wished preset
button for 3 sec., while playing the station that you want to store.
4. When stored, the display will show “Preset X saved”
5. To change between the Modes DAB, FM, AUX, press the “
Source
” (6) button repeatedly
until you reach the preferred Mode.
6. To tune stations in FM Mode press and hold the “
Autotune
” (2) button for 3 sec. and the
RADIO1 will scan to the next available station. You can store FM stations like mentioned
in point 3.
3.2 DAB mode
1. If you are not in DAB mode, press the
Source
(6) button continuously, until it shows
“DAB”. It will start playing on the last played station.
The radio displays the correct time in DAB and FM mode, after a full scan has been
performed in DAB mode (normally done automatically at first time installation). Your radio
retrieves the time information from the DAB network.
2. While in DAB mode, press the
Source
(6) button, and the radio switches to FM mode.
3. While in FM mode, press the
Source
(6) button, and the radio switches to AUX IN mode.
4. You can switch the DAB/FM/AUX IN by pressing
Source
(6) button at any time.
3.2.1 Scanning stations in DAB mode
There are two ways to scan for stations:
•
Automatic full scan (
autotune
(2))
•
Manual scan
To do an automatic full scan:
1. Press and hold the
Display
(5) button for three seconds and <Full scan> will show in the
display.
2. Press the
Tuning/select
(3) button/knob and automatic full scan will start.
This may take a few minutes, during which you will see the displays in the sequence
below.
When there scan is finished the first found station, starts to play immediately.
3. To preview another station, turn the
Tuning
(3) knob until the name of another station
appears.
4. Press the
Tuning/select
(3) button/knob to select and listen to the new station.
