OPERATING INSTRUCTIONS FOR
EZY-STAMP MARKING TOOL
1. Oil EZY-STAMP air hammer in accordance with manufacturer’s instructions; OIL DAILY.
2. Follow manufacturer’s operating instructions.
3. Use only air pressure
4. Use lowest possible air pressure setting.
DO NOT EXCEED 90 PSI MAXIMUM AIR PRESSURE.
5.
Tool requires both hands to operate and mark
. One to locate and hold the stamp against
the part to be marked, and one to hold and push the EZY-STAMP against the stamp while
actuating the trigger.
6. Insert hand stamp into stamp holder of EZY-STAMP. Position stamp face on surface to
mark. Apply pressure to the EZY-STAMP and activate trigger, directing force to the stamp
face center. A legible impression should take 1 to 2 seconds of air hammer application time
per stamp. NOTE: When the trigger is pulled, a series of hammer blows “BURP” will create
the mark. The stamp face may be inserted back into its indentation and a second “BURP” of
the tool can create a deeper impression.
7. You may want to place cylindrical parts smaller than 60 pounds in a cylinder vise for ease of
stamping.
8. Practice stamping on an old cylinder or metal surface to gain marking proficiency.
9. On cylindrical parts, direct force to the stamp face center and roll top to bottom, left to right
in continuous motion. A legible impression could take 5 seconds of air hammer application
time per stamp.
10. Initial air hammer strike to center of stamp face distributes impact force evenly, reduces
compaction stress and helps prevent breakage at stamp shoulder and character edges.
ALWAYS WEAR PROTECTIVE FACE AND BODY GEAR TO
PREVENT INJURY FROM DIE BREAKAGE DURING OPERATION
ARGON TOOL, INCORPORATED
32309 Milton Avenue, Madison Heights, Mi 48071,1-800-466-4664,
Telephone 248-583-1605, Fax-248-588-0051, e-mail [email protected]
REPLACEMENT PARTS IN STOCK
DRIVE SOCKET FOR EZY-STAMP
Holds one hand stamp. Specify your hand
stamp body size. Available to hold 3/8” or 1/2”
square body hand
stamp.
KNURLED
RETAINER
Holds drive
socket in place.