EZY-STAMP
HAND HELD PNUEMATIC MARKING TOOL
ARGON TOOL’s EZY-STAMP
Hand Held Pneumatic Marking Tool
Makes inspection marking quick and easy.
Used for recertification of DOT cylinders.
Stamp holder accommodates one standard
hand stamp at a time. The tools hammer blow
is controlled by air line pressure. Recommended
operating air pressure is 20-90 PSI.
ARGON TOOL, INCORPORATED
32309 Milton Avenue, Madison Heights, Mi 48071,1-800-466-4664,
Telephone 248-583-1605, Fax-248-588-0051, e-mail [email protected]
USE OF THE TOOL REQUIRES BOTH HANDS.
One to locate and hold the hand stamp
against the part to be marked, and one to hold and push the EZY-STAMP firmly against
the stamp while actuating the trigger.
When the trigger is pulled, a series of
hammer blows “Burp” will create the
mark. A one second “Burp” is all that
is required. The stamp face may be
inserted back into its indentation and a
second “Burp” of the tool can create a
deeper impression if desired.
Hand stamps slide into the socket and must be held
in place during the marking process. See proper
marking technique in photo to the right
Made In The
U.S.A.
Tool weights
approximately
4 pounds
EZY-STAMP-250 Kit,
I
ncludes one (1) set of 1/4”
character hand stamp numbers #0 thru 9 and the letter "E".
This tool is normally used for recertification of DOT
cylinders.
Optional 1/8”, 5/32”, and 3/16” stamps available
upon request. Call for pricing.
EZY-STAMP-375 Kit
I
ncludes one (1) set of 3/8” character hand stamp numbers
#0 thru 9 only.