15
Technical Information
Service Manual
1. ON/OFF button
2. MODE button
3. FAN button
6. SLEEP button
5. SWING button
Press this button to turn on the unit. Press this button again to turn off the unit.
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT *,
as the following:
AUTO
COOL
DRY
FAN
HEAT
*
* Note: Only for models with heating function.
* Note: Fan speed under dry mode is low speed.
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to , then back to Auto.
4.▲ / button
▲
▲
Press / button to increase/decreaseset temperature.In AUTO mode,set temperature is not adjustable.
▲
Press this button to set up & down swing angle.
▲
▲
Press this button again to cancel Sleep function. Under Fan and Auto modes, this function is unavailable.
7.
TEMP button
Press this button, you can see indoor set temperature, indoor ambient temperature on indoor unit’s display. The setting
on remote controller is selected circularly as below:
no display
8.
TURBO
button
9. I FEEL button
10.
Timer
button
press this button to activate / deactivate the Turbo function.
Under ON status, press this button to set timer OFF; Under OFF status, press this button to set timer ON.
Press this button to start I FEEL function and " " will be displayed on the remotecontroller. After this function is set, the
remote controller will send the detectedambient temperature to the controller and the unit will automatically adjust theindoor
temperature according to the detected temperature. Press this button againto close I FEEL function and " " will disappear.
When I FEEL function is turned on, the remote controller should be put within the area where indoor unit can receive the
signal sent by the remote controller.
● Press this button once and the characters of HOUR ON (OFF) will flash to be displayed. Meanwhile, press "
▲
" button
or "
▲
" button to adjust timer setting (time will change quickly if hoiding "
▲
" or "
▲
"button). Time setting range is
0.5~24hours. Press this button again to confirm timer setting and the characters of HOUR ON (OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting status will be quit after 5s.If timer is confirmer,
press this button again to cancel timer.
This function indicates that moisture on evaporator of indoor unit will be blowed after the unit is stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF button indoor fan will continue running for a
few minutes. at low speed. In this period, Hold fan speed button for 2s to stop indoor fan directly.
Having set X-FAN function off: After turning off the unit by pressing ON/OFF button, the complete unit will be off directly.
X-FAN function
Hold fan speed button for 2s in COOL or DRY mode, the icon “ ” is displayed and the indoor fan will continue
operation for a few minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
●
●
●
