Argo Service Manual Electrical System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
ES-17
5.
Install the recoil cup and mounting nut to the crankshaft. Torque the flywheel nut to
specifications. Refer to your engine service guide.
6.
Install the blower housing.
When the flywheel is assembled to the crankshaft, use a small technicians mirror to
check the key and keyway alignment.
7.
Install the fuel pump mounting bracket and front engine hook.
8.
Reinstall the fuel pump and reconnect the fuel line.
9.
Attach the main ground cable to the engine.
10. Reassemble the air filter housing and filter back to the top of the engine.
Removing the Brake Cooling Fan (Response, Bigfoot)
Response and Bigfoot models come equipped with a brake cooling system. The cooling
fan is mounted to the upper body by 4 rivets, and air flow is routed via an intake hose to
a brake cooling duct at the brake discs.
1.
Remove the engine access cover.
2.
Perform the servicing procedure, Re-
moving the Intake Duct, in section DE
of this service guide.
3.
Locate the brake cooling fan and
unfasten the gear clamp securing the
hose to the fan. Photo ES-23
4.
Pull the hose from the fan.
11. Perform the servicing procedure, Installing the Intake Duct, in section DE of this
service guide.
5.
Disconnect the power and ground wire
from fan.
6.
Drill out the 4 rivets used to fasten the fan to the upper body. Photo ES-24
Extreme care should be observed when drilling out rivets. Damage can occur to the
upper body if the drill slips and comes into contact with the plastic.
ES-23