Audio Resource Group, Inc. • 405 Main Ave W, Unit 4G • West Fargo, ND 58078 • ©2016
Audio Resource Group, Inc.
Page 5
SETTING COPY:
New ARG receivers have the ability to copy settings from one unit over to another unit. This greatly speeds
up programming multiple units as it takes approximately one minute to copy all settings. To copy from one
unit to another the optional copy module is required. (ARG-PM03).
1.
Program one receiver manually. This receiver will be referred to as the master receiver. The other
receivers will be referred to as slave receivers.
2.
Plug the copy module power adaptor into power and connect two C-SAFE/CAT-5 cables to the copy module.
3.
Remove the headphone jack module from the master receiver and slave receiver by removing the two set screws in
the front of the unit (Note: refer to headphone jack replacement to remove the jack).
4.
Connect the other end of one of the C-SAFE cables from step 2 to the master receiver and the second C-SAFE
cable to the slave receiver.
