1.
On/Off switch
2.
Red LED
3.
Blue LED
4.
Green LED
5.
DC connector
LED functions:
Red LED
The LED lights up when the RPT-7700 is switched on.
Blue LED
The LED flashes when the RPT-7700 receives signals from the sensors
Green LED
–
Off:
–
On:
–
Short ON, long OFF of the LED: Network active, flash memory inactive
–
Long ON, short OFF of the LED: Network active, flash memory active
3. Installation
The RPT-7700 Repeater is externally powered by the supplied mains adaptor. Connect
the supplied adaptor to the DC connector on the rear panel.
OPERATION
Place the Repeater somewhere halfway between the sensor (that is too far away from the
receiver to transmit signals to it) and the receiver. If necessary, several Repeaters can be
set up in sequence!
The Repeater has no controls. Just switch it on and off.
The unit works properly when the red LED remains steadily on and the blue and green
LEDs light up from time to time. This means that the unit receives and transmits signals.
