-2-
6.2 Instructions mechanical assembly
For the assembly of the motor you need;
1 pc. Motor
1 pc. Pinion gear (for motor)
1 pc. Switch
1 pc. Chassis panel
1 pcs. Motorbase
1 pc. Self-Tapping screw M2.3x5
6 pcs. Screw M2x5
4 pcs. Nut M2
4 pcs. Spring washer M2
Install the motor to the motorbase and fix it with
the 2.3x5mm selftapping screw. See drawing.
The shaft must
be fully pushed
into the gear !
Hit slightly with the hammer,
do not hit the terminals!
OR BETTER:
Push the gear on the shaft
with your hands.
Assembly motor pinion
Install the motorbase and switch
First always collect all the parts, as mentioned
in the "parts you need list", before you start
the assembly!
On this side there
are 2 bosses !
Be sure the motor is fixed properly
with the 2.3 x 5 mm tapping screw.
Flat part is faced down
Push the motor wires on the motor terminals.
Use a plier to insert and remove the wires.
Insert the wires into the holes of the chassis panel.
See drawing.
Orange (+)
Blue (-)
