15
16
Trouble shooting
How to
change the
camera
network to
another
router?
First reset the device or remove it on the
Arenti App and then configure the device
again by the App.
Why doesn’t
the device
identify the
SD card?
It’s recommended to plug SD card after
power cut. Confirm whether the SD card is
normally available and the format is FAT32.
And the SD card can’t be identified when
the Internet environment is not good.
10. FCC STATEMENT
For further online assistance or customer service team
please visit our official website.
www.arenti.net
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1- this device may not cause harmful interference,
2- this device must accept any interference received, including
interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications or change to this equipment.
Such modifications or change could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
