2/4
SPT2008
GETTING STARTED
Open the shipping carton and verify that all
equipment necessary to operate the system has
arrived intact. Refer to the following packing list
for information on what items are included with
your model. If any equipment is missing or
damaged, contact your Arena Luci dealer
immediately.
n° 1 Soul LED SPT2008
n° 1 fixing polyurethane disk
n° 1 8mm Allen key
Before beginning initial setup of your projector,
make sure that there is no evident damage
caused by transportation. In the event that the
unit’s housing or cable is damaged, do not plug it
in and do not attempt to use it until after
contacting your Arena Luci dealer for assistance.
INSTALLING THE DEVICE
Before carrying out any operation, remove the
mains voltage from the system.
The appliance can be installed on the floor, wall or
ceiling. Always make sure that the structure on
which you are fixing the appliance is safe and is
able to bear the weight of each unit.
Unscrew the two side dome nuts of the base and
take out the lower fixing plate.
Using the fixing plate as a reference, drill two
holes with a 45mm center distance.
Fix the base plate on the structure with screws
and expansion plugs of the type most suited to the
weight of the appliance and the type of structure
on which you intend to install the appliance,
interposing the polyurethane disk from which you
can detach the preshaped parts for passage of
screws and cables. The disc has an adhesive
face: remove the white protective film and stick
the disk to the structure. Then place the base
plate on top of the disk, taking care to position the
central slot of the plate in correspondence with the
hole for the passage of the electric cables.
Pass the power cable through the central slot of
the fixing plate, then proceed to the electrical
connection.
The appliance is equipped with a preassembled
power cable, so the electrical connection must be
made before fixing the appliance to the structure.
Use the appliance's power cable for connection to
the mains, paying attention to the voltage and
frequency indicated on the rating label.
To prevent moisture rising inside the appliance it is
advisable to use suitable connection systems,
such as anticondensation joints, selfcaking
bands, thermocoating sheaths.
Respect the polarity LNE indicated on the
terminals (colors brown = L, blue = N, yellow /
