Arena Luci BARIO LED User Manual Download Page 1

Page: 1 / 8

This  instruction  manual  contains  important  information
about  the  installation  and  use  of  the  projector.  Please
read and follow these instructions carefully.
The  security  of  this  device  is  guaranteed  only  with  the
proper  use  of  the  following  instructions,  therefore  they
must be kept carefully.
Never install the device in locations easily accessible by
people  who  ignore  the  existence  of  this  user's  manual
and safety instructions.
Disconnect  the  unit  from  any  power  supply  before
attempting any operation in contact or inside the unit, and
when not in use.
It is essential that each device is correctly earthed and
that  electrical  installation  conforms  to  all  relevant
standards. Never supply the unit without the earth link.
Prior to connect the unit to the mains supply, check the
output voltage fits technical requirements on the label.
Never let power cord come into contact with other cables.
Never touch electrical contacts, either directly with your
fingers, or indirectly by means of sharp or metal objects.
Make sure that cables cannot cause trip hazard.
Do not attempt to dismantle and modify the unit.
Due  to  high  technological  level  of  this  unit,  service
maintenance should be performed by specialised opera
tors. Please contact your Arena Luci dealer for any issue.
Always  ensure  that  the  structure  to  which  you  are
attaching  the  unit  is  secure  and  is  able  to  support  the
weight of each unit.
Always  make  sure  you  are  using  a  safety  chain
connected to the unit.
Do  not  allow  contact  with  water  or  any  other  fluids,  or

metallic objects (IP 20).
Do not install the projector in areas of high humidity. The
unit is intended only for indoor purposes.
Avoid installing the unit close to heat sources.
Never lean the power cord on hot unit surfaces.
Allowed to be mounted directly on inflammable surfaces.
Keep a minimum distance of 3m between the device and
the illuminated surfaces.
Avoid direct exposure to the light from the lamp. The light
luminance is harmful to the eye.
Install the unit where it can be easily aerated.
Avoid obstruction of in/out vents.
The  lighting  apparatus  must  be  used  only  with  its
protective shield.
The  protective  grill,  lenses  or  ultraviolet  filter  must  be
changed if they are visibly damaged to the point at which
their  effectiveness  is  diminished,  for  example  by
becoming cracked or deeply scratched.
To ensure the reliability of the projector it should be kept
clean.  The  lens  and  filters  should  also  be  regularly
cleaned (at least once every six months) to maintain an
optimum light output.
Do not use any solvent based cleaning agents. Use only
a soft, dry antistatic cloth.
The  installation  of  LED  modules  (including  power
supplies) should be done according to current technical
rules  and  regulations.  The  installation  should  be
performed only by a qualified operator.
Avoid  contact  with  either  corrosive  agents  or  humidity
and  moisture  on  delicate  elements:  damages  from
corrosion are not refunded as component defects.