Original User Manual
–
A
REBO
S Upright Vacuum Cleaner Eco
5
17.Floor Brush LED Lamp
18. Wall mountable Charger/Adapter
19. Combined Crevice Nozzle
20. Crevice Nozzle
Unpacking the Device
1.
Remove the device from its packaging.
2.
Check the delivery scope for completeness.
3.
Check the device for any transport damage, in order to prevent hazards.
4.
Remove the transport lock from the multifunction button
.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged device!
Notes on Use
•
The device is especially suitable for quickly vacuuming small amounts of dry dirt or dust.
•
The device is operated via charged battery. Charging is done via the supplied power supply
unit.
•
Direct power supply via mains adapter is not possible.
Multifunction Button
Use the multifunction button to turn the device on and off.
Also select a power level with this button.
Press once = Turn on the device, low power level
Press twice = Select high power level
Press three times = Turn off the device
Start-up
Suction Tube
•
Insert the suction pipe with the two contact pins into the connection on the hand unit. It
must audibly engage.
•
To disconnect the suction pipe, press the release (14) and pull out the pipe at the same time.
Floor Nozzle with Turbo Brush
The floor nozzle is suitable for any floor covering. During operation, the LEDs on the floor nozzle light
up for better visibility in dark areas.
Caution: You cannot replace the LEDs.
•
Slip the lower end of the suction pipe onto the connector on the floor nozzle. Pay attention
to the contact pin. The suction pipe must audibly engage.
•
To release the suction pipe, push the release (11) away from the suction pipe and pull out the
pipe at the same time.
