22103-017
22103-004
Final adjustments.
Close the door, check the door for
proper operation. It should not bind against the door
frame. If necessary, adjust the position of the cap again.
Trucks without utility tracks use clamp kit
22103-004.
To install the clamps (C) align them
with the metal clamp plate on the rails. Use a 9/16” wrench
to tighten all clamps.
10
11
Clean and remove all stickers.
14
12
13
Trucks with utility tracks require clamp kit 22013-017
. The clamps (D) install by removing the utility track end cap
and sliding the clamp block into the utility rail. Position the clamps by aligning them with the metal clamp plate on the rails.
Use a 9/16” wrench or an Allen wrench to tighten all clamps. Replace the utility track end caps when the clamps have been installed.
Hook the lights up using the wire harness (E) included with the cap and automotive connectors and fuse links.
12volt lights should run directly to the battery.
A.R.E. Accessories
• 400 Nave Road, Massillon, OH 44648 • 866.658.8376 • 4are.com © A.R.E. Accessories LLC, 2021
Part# 24953 Rev. 12-15-21