5. Wiring
Fixed wiring installation should be carried out by a qualified person. Power requirements are - 220 -240 Volt AC 50 Hz
(1.4kW). Connect fixed wiring to the terminals marked L and N and ground. This dryer is a Class I appliance and requires
an electrical earth (ground). Suitable fixed wire conductor size - 1.0-2.5 mm2.
6. Refitting the cover
When the wiring connection is completed, move the cover into position and secure the it with the two side fixing
screws. The dryer is now ready for use.
7. Testing and Operation
Turn power on. The dryer will commence immediately hands are placed under the dryer.
Regular Operation
–
The dryer blower will run while hands are placed under the dryer and will stop when hands
are removed.
8. Dry Your Hands Fast
Shake excess water from hands to speed drying. Place hands beneath the air outlet.
Rub and rotate hands in the hot air stream and continue drying until there is no moisture left on hands.
9. Maintenance of your dryer
Clean the exterior cover enclosure using non-abrasive detergents and a soft cotton cloth.
Check the carbon brushes every three years.
V1 061113
241mm
258
Flexible cord exit
Screw dryer to wall here
Screw dryer to wall here
Diagram 1
NEW ZEALAND
ARDRICH LIMITED
P + 64 9 570 2861
F + 64 9 570 2864
E [email protected]
AUSTRALIA
ARDRICH HYGIENE PTY LIMITED
P 1 800 058 655
E [email protected]
SOUTH AFRCA
SERVEST HYGIENE
P + 27 11 608 1888
E [email protected]
A266SS/W VELOCITY