Ardo DPG24SH, Operating Manual, Page: 63 / 97

62
Taking out and putting in the shelves
Slide the shelf out, then slide it in as much as
possible so that its clamp could fit the guide
groove (fig. 16).
Bulb replacement
1. Set the knob at "OFF", then unplug the
appliance.
2. Pull away the bulb cover bracket and remove
it (photo 15).
3. Replace the bulb with a working one with the
following specification: 220 - 240 V, max. 15
W, E14 thread, maximum bulb dimensions:
diameter - 26 mm, length - 55 mm.
4. Replace and secure the bulb cover.
Taking out and putting in the door
shelf
Lift the door shelf, remove it and put it back
from the top into its required position (fig.
17).
16
17
15
Do not use bulbs of greater or
smaller power, apply only the
bulbs of parameters given above.
14
You must not put an electric heater, a heat -
ing fan or a hair dryer into the freezer by
any means.
1. Set the knob at ”OFF” position, take out
the plug from the mains socket.
2. Open the door and remove the food from
the freezer.
3. After about 0.5h, it is possible to remove
the white frost or water from the smooth wall
surfaces (fig. 14).
4. Wash the interior of the freezer and wipe
it dry.
5. Switch on the appliance as per the rel
-
evant point in the manual.
DEFROSTING, WASHING AND MAINTENANCE