EN
21
5.6 To operate the convector on the floor, install the supports according to figures
4.1 - 4.3.
To install the supports, put the convector on a horizontal surface with the base up.
Fig. 4.1
Fig. 4.2
Fig. 4.3
Install the hooks of the support (Fig. 4.1) in the corresponding
holes of the air intake grid so that the holes for screw fixing in the
support and along the edges of the convector base coincide, fix
the support with a screw (Fig. 4.2). Secure the other support in
the same way. Place the convector in operating position on a flat
surface (see Fig. 4.3).
The placement of the convector on supports in the room is similar
(see Fig. 3), while the distance from the rear wall of the convector
to objects (furniture, curtains, etc.) should be at least 15 cm.
5.7 Turn the switch key to the off position “0”, set the thermostat
knob to the “
” position (connect the “
” sign on the knob with
the mark on the control unit). The convector is ready for operation
(the location of the convector controls is shown in Fig. 5).
6. OPERATION
Warning!
It is strictly prohibited to turn on and operate
the convector without fixing it to the brackets on the
wall or on the floor without the installed supports.
Turning on and operating the convector is allowed only
in the position indicated in Fig. 1 (intake grid down).
When you turn on the convector for the first time,
the smell of evaporation of preservation materials is
possible. It is recommended to ventilate the room.
6.1 Turning the convector on.
Plug the power cord of the convector into a power outlet. Set the thermostat knob
near the “MAX” position. Turn on the convector by moving the switch key to the «I»
position.
Fig. 5
