ARDESTO AP-200-W1, Instruction Manual, Page: 56 / 70

Composition of the filter net
Clean air outlet
Pollution air inl
et
If the product picture is different from the actual product,
the actual product shall be prevail
Turn on the air purifier
After plugged in the power ,all the indicator
lights(except the air quality indicator light) will
be on ,then the indicator light of power will be
half on,the machine will enter standby mode.
Press ON/OFF button (as shown in above
figure),the air purifier will start to work,in the
beginning 30 seconds,the smart sensor
needs to preheat(the indicator light of air
quality will be in blue,the PM 2.5 value will be
shown as “———”),after 30 seconds’
preheating,the smart air quality sensor will
detect the air quality automatically .It will
show the air quality by different indicator
light colour (as shown in below figure).
indicator light color of air quality
blue
green
red
good
ordinary
poor
Reminder
Auto mode
A AU UTTO O
After plugged in the power,the air purifier
enters standby mode.Press ON/OFF button,
the machine will start to work and enter auto
mode.Under this mode,the air purifier will
choose wind speed automatically according
to the indoor air quality.