Owner’s Notes for
Ardent
March 26
th
, 2021
36
o
It takes about 30 minutes of running the engine under load to get the water hot. CAUTION:
Engine heated water may be scalding hot. Please BE CAREFUL!
o
When on shore power, you can heat your water using electric coils by turning on the WATER
HEATER switch on the AC panel.
State parks do not have pressurized water to refill tanks, but all points of civilization do.
Enjoy your vacation aboard
Ardent
!
29.
Appendix 1: Restoring Standard Settings for B&G MFDs (chartplotter)
The B&G MFDs are fully customizable. If you decide to change a setting or if a setting is changed by mistake,
please use the following procedure to restore the original settings.
1.
Press “Pages” button – this is a “hard” button around the rotary knob in the upper right corner
2.
Select “Tools” – soft button at bottom of screen
3.
Select “Files”
4.
Select “My Files”
5.
Use rotary knob to highlight “SJS-Settings. Set” file then select by pressing in the rotary knob
6.
Select “Import”
7.
Select “Yes” at restart warning.
NOTES: It will take a few minutes for the MFDs to reset. Each MFD must be reset individually.