arcweld 210C MIG, Operator'S Manual, Page: 12 / 31

C-2
INSTALLATION
C-2
Do not attempt to use this equipment until you have thoroughly read all operating
and maintenance manuals supplied with your machine. They include important
safety precautions, detailed operating and maintenance instructions and parts lists.
ELECTRIC SHOCK can kill

Do not touch electrically live parts or electrode with skin or wet clothing

Insulate yourself from work and ground

Always wear dry insulating gloves.
Only qualified personnel should install, use or service this equipment.
Location and Ventilation
Whenever you use the
arcweld
®
210C/250C MIG inverter STICK / TIG / MIG Welder be
sure that clean cooling air can flow around the front and rear louvres, (there should be
500mm clearance for good ventilation). Avoid dusty, dirty areas, particularly if
conductive particles are present in the cooling air. Also keep the machine away from
heat sources. If operation is to be outdoors protect from rain and do not sit in puddles
or otherwise submerge it in water. Such practices pose safety hazards and cause
improper operation and corrosion of parts.
Always operate the
arcweld
®
210C/250C MIG Inverter Welder with all panel work
installed to enable correct cooling air flow and protect you from possible electric shock.
Storing
Store the machine in the permissible range of -25 ~ +55
℃
, in a dry place when it is not in
use. Protect it from dust and dirt. Keep it were it cannot be accidentally damaged
from construction activities, moving vehicles and other hazards.
Stacking
The
arcweld
®
210C/250C MIG Inverter Welder CANNOT be stacked.
Tilting
Place the
arcweld
®
210C/250C MIG Inverter Welder on a secure, level surface
whenever you use it or store it. Any surfaces you place it on other than the ground
must be firm, non-skid and structurally sound.