REPLACING CUTTING EDGES
27
26
www.
arcticsnowproducts
.com
Arctic Sectional Sno-Pusher™
Owner’s Manual
REPLACING POLYBLOCKS
REQUIRED TOOLS
Ɉ
Impact wrench
(Highly Recommended)
Ɉ
Standard 15/16” Impact Swivel
Socket
(Regular or Deepwell)
1. Remove nuts and bolts to free the polyblock being replaced.
2. Attach the new polyblock to moldboard
first using hex bolt, flat
washer
(A)
and poly block washer
(B)
,
just starting the nuts to hold in
place (do not fully tighten)
3. Secure opposite end of the polyblock on mainframe using flange bolts
and poly block washer, then tighten down all fasteners with 100 ft
lbs. (lbf-ft) torque.
Depending on user preferences and operator training, moldboard limiters and heavier duty
polyblocks are available for LD and HD series Sectional pushers. See your dealer or contact the
Arctic Sales representative in your area for more information.
Note:
The top and bottom polyblocks differ in thickness. Make sure the thinner
polyblock goes on the top and the thicker one on the bottom.
Please report any Arctic dealer that is selling or suggesting the use of aftermarket parts.
A
B
1. Remove nuts
(A)
and bolts
(B)
to detach old cutting edge. Frozen nuts
may be removed with torch if necessary.
2. Place bolts into recessed holes
(C)
on the new cutting edge, then
through trip edge mount
(D)
and start nylon lock nut. Be sure to hold
the bolts flush against the cutting edge when tightening nut on back
side until secure.
Depending on buyer preferences, a variety of specialized and extreme
duty cutting edges are available. Contact your dealer or Arctic sales
representative in your area for more information.
Note:
Top of bolt must be completely flush against the face of the cutting blade.
Note:
We recommend replacing all fasteners. Use 5/8-11 plow bolt with nylon
lock nut.
REQUIRED TOOLS
Ɉ
Impact wrench
(Highly Recommended)
Ɉ
Standard 15/16” Impact Swivel
Socket
(Regular or Deepwell)
A
B
C
D
MAINTENANCE & REP
AIR
MAINTENANCE & REP
AIR
