Arctic AG10E, Owner'S Manual

Page: 4 / 31

AG6E/AG8E/AG10E
Page 4 www.arcticsnowplows.com
Safety and warnings
WARNING:
- Do not exceed the gross vehicle weight ratings (GVWR), front gross
axle weight rating (FGAWR) or rear gross axle weight rating (RGAWR) with
spreader and load. Overloading could result in an accident or
damage.
(Refer to Material Density chart below)
Material Density
(lb per cubic yd)
Fine Salt
– Dry 1400
Coarse Salt
– Dry 1300
Coarse Sand
– Dry 2800
Coarse Sand
– Wet 3300
For Electric sander with the variable speed box:
- Never hook booster cables directly to the motor; this would void your
warranty.
-Unplug sander battery cables before boosting your truck.
Before attempting any procedure in this book, read and understand all the safety
information contained in this section. In addition, ensure all individuals working
with you are also familiar with these safety precautions.
For your safety, warning and information decals have been placed on this
product to remind the operator to take safety precautions. It is important that
these decals are in place and are legible before operation begins. New decals
can be obtained from Arctic Equipment Manufacturing or your local dealer.
Remember it is the owner’s responsibility for communicating information on the
safe use and proper maintenance of this equipment. The careful operator is the
best operator. Most accidents are caused by human error. Certain precautions
must be observed to prevent the possibility of injury to operator or bystanders
and/or damage to equipment.
- Driver to keep bystanders a minimum of 25 feet away from operating spreader.
-Servicing the sander without special tools and knowledge could result in
personal injury. See an authorized Arctic dealer for service.
- Before servicing the spreader, wait for conveyor or spinner to stop and then
lock out power.
- Do not climb into or ride on spreader.