34
PR332A
3. Finish removing the cap screws and flange nuts
(from step 2); then remove the hood assembly.
CLEANING AND INSPECTING
1. Clean all hood components with soap and water.
2. Inspect the hood for cracks and/or loose fasteners.
3. Inspect for any missing decals.
INSTALLING
1. Place the hood into position on the vehicle; then
install the two outside cap screws and flange nuts.
Finger-tighten only at this time.
2. Open the hood; then install the remaining two cap
screws and flange nuts. Tighten all four securely.
PR332
3. Connect the four headlight connectors; then secure
the wires with two new nylon ties.
PR332B
Fenders
REMOVING
Remove three torx-head screws securing each fender to
the frame. Account for a stiffener bracket on the front
fenders.
PR311A
INSTALLING
Place the appropriate fender into position and secure with
existing hardware.
Floor
REMOVING
1. Remove the seats and center console.
2. Remove the cap screws and self-tapping screws
securing the floor to the frame.
3. While pulling forward on the upper-rear of the floor,
lift the rear part of the floor above the seat lock stud.
NOTE: To aid in removing, insert a small wood
block to hold in position.
PR163