59
MD1117
9. Install the air intake plate. Apply red Loctite #271 to
the threads of the three Phillips-head cap screws;
then install and tighten securely.
MD1342
10. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loctite
#271). Tighten to 147 ft-lb.
MD1068
KC134
11. Slide the fixed drive face assembly onto the front
shaft.
12. Spread the faces of the driven pulley by threading a
V-belt cover cap screw into the fixed driven face and
tightening until the faces open sufficiently to allow
the V-belt to drop into the pulley approximately 3/4
in.
KC137
NOTE: The arrows on the V-belt should point in
direction of engine rotation.
13. Making sure the movable drive face rollers are in
position, pinch the V-belt together near its center and
slide the spacer and movable drive face onto the
shaft.
KC127
14. Coat the threads of the nut with red Loctite #271;
then making sure the splines of the clutch shaft pro-
trude through the cover plate, secure with the nut and
tighten to 147 ft-lb.
KC138