Arctic Cat 2009 366, Service Manual

Page: 20 / 139

2-13
2
KC163B
5. Connect the wiring harness connector to the bulb;
then install the protective rubber boot making sure
it seals completely on the headlight harness.
KC146
TAILLIGHTS-BRAKELIGHTS
To replace a taillight-brakelight bulb, use the follow-
ing procedure.
1. Turn the bulb socket assembly counterclockwise
and remove from the housing.
KC157
2. Press in and turn the bulb counterclockwise to
remove. Press in and turn clockwise to install the
bulb.
3. Insert the bulb socket assembly into the housing
and turn it clockwise to secure.
RUNNING LIGHTS/BACK-UP
LIGHTS
The running lights are located outboard of the head-
lights, and the back-up lights are outboard of the tail-
lights/brakelights. To replace the bulbs, use the
following procedure.
1. Rotate the bulb socket counterclockwise to release
from light housing; then press in on the bulb and
turn counterclockwise to release from the socket.
KC158A
2. Install a new bulb and press in rotating clockwise
to secure; then place the socket into the light hous-
ing and turn clockwise to secure.
KC158B
CHECKING/ADJUSTING
HEADLIGHT AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light
zone is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming
surface (wall or similar aiming surface).
Back to TOC Back to Section TOC
Next Back