Arcserve UDP 8300, Installation Manual

Page: 8 / 16

Adjustable, fixed quick rail assembly
A
A
B
B
Insert the quick
rail assembly
hooks through
the square hole
openings in the
rack. The release
buttons secure
rails in place.
Release
buttons
Quick rail
assembly
hooks Quick rail
assembly
hooks
C
C
Arcserve UDP 8300 and UDP 8400 Appliance Hardware Installation Guide
8
6A. 4-Post Rack Installation (square holes)
Step 2
A
A ttach a qu i ck ra i l asse m bly i n the
front (on one s i de) of the rack. Insert
the asse m bly hooks, w i th the hook
fac i ng down, through the open i ngs i n
the rack. The release tabs secure the
ra
i ls i n place (as shown i n the deta i l
i llustrat i on on the r i ght).
B
Pull the ad
j
ustable ra
i
l asse
m
bly
backward toward the back of the rack.
The back sect
i
on extends to ad
j
ust to
the proper rack depth.
*
C
Insert the rear qu i ck ra i l asse m bly
hooks, w i th the hook fac i ng down,
through the open i ngs i n back of
the rack.
*
A ttach the other ad j ustable, f i xed, qu i ck
ra
i
l asse
m
bly to the rack follow
i
ng the
steps
A
through
C
above.
*
Step 1
Locate the two adjustable standard rack rail assemblies.
n Re m ove the i nner f i xed chass i s ra i ls fro m the ad j ustable, qu i ck ra i l asse m bl i es
n
Pull each i nner f i xed chass i s ra i l out as far as poss i ble. Press the lock i
ng tab down to pull the chass
i
s ra
i
ls
co m pletely out.
n Put these ra
i
ls as
i
de for later
i
nstallat
i
on on the appl
i
ance.
NOTE: The installation procedures
for 6A, 4-Post Rack, below are for
use with the rails and hardware
provided in your ship kit. If different
style rails are being used, or if your
rack requires different hardware,
refer to the instructions provided
with your rail’s or rack’s ship kit.
1. Press the middle
rail toward the chassis
with thumb.
2. Aim the inner
rail into the middle
rail until fully seated.
2
1
CAUTION!
The chassis is heavy.
The installation procedure
requires minimum of 2 people.
R
Inner fixed chassis rail
Adjustable, rear section of the fixed quick rail assembly
Sliding rail (part of quick rail assembly)
Locking tab
Rev. B
Need Rev. B inner rail
NOTE: Make sure the quick rail assemblies
are aligned in the rack not only in the
front and back, but are level in height on
the left and right sides for proper alignment
for appliance installation.
*