4 Operation
4.1
Layout Of The Front And Rear Panel
Fig 4.1 schematic drawing of the front panel and rear panel
1.
Power pilot lamp
2.
Over-current, over-heat alarm -when over-heating or over-current the lamp will light up.
3.
Cutting torch improper installation / low air pressure alarm
4.
Work lamp – lights when unit is on.
5.
Cutting current regulator - it is used to regulate the current when cutting.
6.
Normal Cut
Grid Cut
Note:
Check air for 10 seconds. During this process, press and release the torch switch
quickly and the air check will conclude.
7.
Positive output cable - connected to the workpiece
Summary of Contents for ARCOCUT G-100i
Page 1: ......
