3
Your tool is now ready to work. Insert rivet mandrel into nosepiece. Insert rivet into
predrilled hole in application and pull trigger button and hold until rivet sets then
release the trigger. A second pull may be required.
CLEANING & CHANGING OF JAWS
With use, the jaws of the tool may become dirty or worn. This will cause slipping of
the rivet mandrel & and improper setting of the rivet. To clean the jaws follow this
procedure.
1. Disconnect air supply.
2. Use a suitable wrench, unscrew frame head and remove.
3. Using a pair of wrenches, disassemble front jaw case from rear jaw case.
DO NOT MOVE rear jaw case as this will affect tool operation.
4. To clean jaws, use a stiff dry wire brush.
5. If excessive wear is apparent, replace with new jaws.
6. Reassemble the jaw case assembly.
LIMITED TOOL WARRANTY
This warranty applies to the purchaser of the tool for original use only.
All other warranties, whether expressed or implied, including any warranties of merchantability or fitness
for purpose are hereby excluded.
CHANGING NOSEPIECES
1.
After selecting the correct size nosepiece for the rivet being used
Connect tool to air supply and pull trigger and hold trigger button.
2. Using wrench (supplied), unscrew nosepiece from frame head &
replace with proper size nosepiece. Tighten down with wrench. DO
NOT OVERTIGHTEN. Release trigger.
A
rconic
Fastening Systems - Marson division warrants that this tool will be free from defects in material
and workmanship under normal service and for ninety (90) days from the date of purchase.
Should this tool fail during this ninety (90) day period, and no unauthorized repairs have been made, return
the tool freight prepaid to the factory for free of charge replacement of any part or parts found by A
rconic
Fastening System
s
- Marson division to be defective due to faulty material or workmanship. This represents
the sole obligation of A
rconic
Fastening Systems - Marson under this warranty. In no event shall A
rconic
Fastening Systems - Marson division be liable for any consequential or special damages arising from the
purchase or use of this tool. You may have other rights which vary from state to state.
IF further maintenance is beyond the scope of this manual and the tool fails to function properly, contact
the factory or return it to the factory for service.
Contact our Tool Repair Center at 209-839-3032 for further information
.
