7
2015 series Pneudraulic Installation Tools
(HK958)
p
reparation
for
u
Se
The
2015
tools ship with a plug in the air inlet
connector. The connector has 1/4”-18 female pipe
threads to accept the air-hose fitting. Huck recommends
quick-disconnect fittings and a 1/4” inside-diameter
air hose. The air supply should have a filter-regulator-
lubricator unit and access to 90 psi (
6.2 bar
), capable of
a flow rate of 2.9 CFM (
170 l/m
).
NOTE
:
Quick-disconnect fittings and air hoses are
not available for purchase from Huck International,
Inc. Huck includes an air hose (P/N 115436) to
facilitate immediate tool use.
1. Remove the shipping plug from air inlet connector
and add a few drops of an approved hydraulic fluid
.
2.
Screw the quick-disconnect fitting into the air inlet
connector.
3. Set the air pressure on the regulator to 90 psi (
6.2
bar
), and connect the air hose to the tool and the air
inlet connector.
4. Press and release the trigger a few times to cycle
the tool.
5. Disconnect the air hose from the tool, and remove
the retaining nut. Select the proper nose assembly
for the fastener being installed.
6.
Connect the air hose to the tool and install fasteners
in a test plate of proper thickness with proper size
holes. Inspect the fasteners.
If the fasteners do not pass inspection, consult the
T
roubleshooTing
section to investigate possible causes.
Threadmate is a registered trademark of Parker Intangibles, LLC.
TEFLON is a registered trademark of E. I. du Pont de Nemours and
Company.
WARNING:
To avoid pinch points, be sure there is
adequate clearance for tool and operator’s
hands before proceeding. Tool moving
toward structure may crush hands or
fingers between tool and structure if
clearance is limited.
WARNING:
As applicable, do not use without
deflectors or pintail bottles.
If deflectors are removed or damaged,
separated pintails may eject forcibly from
rear of tool. Unshielded eyes, especially,
may be permanently injured. Other severe
injuries can be caused by flying pintails.
If there is any chance of a projectile-like
ejection, always point rear of tool in a
safe direction, or be sure there is some
structure that will stop ejecting pintails.
CAUTION: Do not use TEFLON
®
tape on
pipe threads. Tape can shred and break free
into fluid lines, resulting in malfunctions.
Threadmate
®
is available in a 4oz. tube from
Huck (P/N 508517).
