ArchWork ARCSKY90RGBW, User Manual

Page: 33 / 44

11
ARCSKY90RGBW
DMX512 Controller
DMX Address: 33 DMX Address: 54 DMX Address: 47 DMX Address: 40
. . . . . . . . . . . .
3.4 DMX CONFIGURATIONS
ARCSKY90RGBW is equipped with 8 DMX configuration:
• Press the button MENU so many times until shows [PERSON] , and press the button ENTER to confirm.
• Select the desired DMX configuration [ARC1 - ARC1+D - ARCFULL - REMOTE - SOLID - ARC2 - ARC2+D - SPECIAL2]
through the buttons UP/DOWN.
The tables on page 13 indicate the operating mode and DMX value. As DMX interface, the unit has a 3-wire
signal cable.
3.5 DMX MODE
• Press the button MENU so many times until the display shows
[DMX]
.
• Press the button ENTER to confirm.
• Press the buttons UP and DOWN to select the desired value [001 - 512], old to scroll quickly.
• After setting the value is saved automatically.
3.6 DMX ADDRESSING
To able to operate the ARCSKY90RGBW with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the ARCSKY90RGBW.
The other functions of the light effect panel are then automatically assigned to the following addresses.
An example with a start address 33 and configuration to 4 and 7 DMX channels:
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
4 33 33-36 37 41 45
7 33 33-39 40 47 54
Example 7 DMX channels configuration (mode ARCFULL):
DMX connection employs shielded pair-twisted cables, 2 poles with 120Ω
impedance and low capacity. For connection, refer to the connection diagram
shown on page 7.
Over long runs can be necessary to insert a DMX level matching amplifier.
For those connections the use of balanced microphone cable is not recommended
because it cannot transmit control DMX data reliably.
Fig.9