ArchWork ARCPOD48Q, User Manual

Page: 13 / 44

11
ARCPOD48Q
3.12 SW VERSION
To view the software version installed on the device, proceed as follows.
• In the main menu of the DATAMASTER select
RDM .
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the
Sw Version , then press the ENTER but-
ton to access to next menù to view the software version of the device.
• Press the MENU button repeatedly to exit the menu.
3.13 UID
To view the UID of the device, proceed as follows.
• In the main menu of the DATAMASTER select
RDM .
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the
UID , then press the ENTER button to
access to access to next menù to view UID of the device.
Press the MENU button repeatedly to exit the menu.
3.14 FACTORY DEFAULT
To reset the device of the factory default proceed as follows:
• In the main menu of the DATAMASTER select
RDM .
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the
Factory Default , then press the ENTER
button to access the next menù to choice the Yes or No .
• Press the MENU button repeatedly to exit the menu and to save the changes made.
3.15 MANUAL COLOR
To enter this mode proceed as follows:
• In the main menu of the DATAMASTER select
RDM.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the
Manual Color then press the ENTER but-
ton to access.
• Use the arrow buttons to set the desired mixing color ( Red, Green, Blue, White ) with the relative value ( 000-
255 ). Press the ENTER button to confirm.
• Press the MENU button repeatedly to exit the menu and to save the changes made.
• NOTE: once you have set up the mixing of desired colors with the mode described, to change this at a
later time it is necessary to start again with the Factory Reload mode.
3.16 EFFECTS MODE
To enter this mode proceed as follows:
• In the main menu of the DATAMASTER select
RDM .
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the
Effects then press the ENTER button
• to access.
• Use the arrow buttons to set the desired effect (
Effect1, Effect2, Effect3, Effect4, Effect5, Effect6, Effect7, Effect8,
Effect9 ) with the relative value ( 000-225 ). Press the ENTER button to confirm.
• Press the MENU button repeatedly to exit the menu and to save the changes made.
NOTE: once the desired effect has been set with the described mode, to change it at a later time it is neces-