Arcflash Labs EMG-01 Alpha, User Manual, Page: 10 / 16

10 | P a g e
4. Insert fuse at an angle as shown below. Connect one terminal, then rotate to connect the
other terminal. Once both terminals are connected, do not remove the fuse – press in
firmly until the fuse is fully seated in its terminals. If you accidentally disconnect the fuse
during insertion, let the system fully power down before re-inserting.
5. Once the fuse is inserted, the primary computer should begin to boot up. Wait for the
message that says “press button to charge caps”. When you are prepared to use the gun,
press down on the rotary dial to energize the system. For safety: make sure there is no
magazine inserted.