a) Water inlet hose
3. Water connections
HOT
COLD
Connect the cold water using the hose with blue printing and connect
the hot water using the hose with red printing.
Hot water supply (only for hot and cold water inlet machines)
Pressure: 1-10 bar Temperature: 60°C max. A hot water supply fed from a separate cold water tank will
normally be suitable. Open outlet gas or electric water heaters must not be used. Multipoint water
heaters or combination boilers may be suitable if they are designed to supply washing machines.
(Check your boilers operation instructions or supplier.)
2. Feet adjustment
Cold water supply
For proper operation, the pressure of water should be between 1 and 10 atm. (1 atm corresponds to
more than 8 liters per minute flow rate at fully open tap.)
To prevent water leaks sealing washers are supplied with the water inlet hose inside the machine,
place these on each of the hose ends and tighten both ends fully.
In order to prevent any water leak damages, keep the water taps closed when not in use. Connect the
cornered end of the hose to the machine water inlet.
17
In order for quiet and stable operation, the machine should be placed properly and leveled on its feet.
Your machine comes with two adjustable feet. If the machine is unstable, loosen the plastic counternut
and screw or unscrew the adjustable foot until the machine is leveled perfectly. After positioning,
tighten the counternut for stability.