1 02/07/2020
Model A20018
3 Ton Aluminum Floor Jack
For Technical Questions, Call: 1-800-879-7316
WARNING INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels
are lost or not legible, contact
Arcan Customer Service
for a free replacement. If the operator is not fluent in English, the product and
safety instructions shall be read to and discussed with the operator in the operator’s native language by the purchaser/owner or his
designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use
and operation of equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper
use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, overloading,
off–centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before operating this device.
•
Inspect the jack before each use. Do not use if damaged, altered, modified, in poor condition, leaking hydraulic fluid or unstable
due to loose or missing components. Make corrections before using.
•
Use only on a hard level surface capable of supporting load and free from obstructions so the jack is free
to reposition itself during lifting and lowering operations.
•
Lift only on areas of the vehicle as specified by the vehicle manufacturer.
•
User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
•
Do not use jack beyond its rated capacity. Do not shock load.
•
THIS IS A LIFTING DEVICE
.
Immediately after lifting, support the vehicle with jack stands
capable of sustaining the load before working on the vehicle.
•
Center load on saddle. Be sure setup is stable before working on vehicle.
•
Do not move or dolly the vehicle while on the jack.
•
Do not use any materials that may serve as risers, spacers or extenders between the stock lifting
saddle and the load.
•
Do not use any adaptors that replace the stock lifting saddle unless approved or supplied by the jack manufacturer.
•
Always lower the jack slowly and carefully.
•
Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the manufacturer's
authorized representative.
• Failure to heed these warnings may result in fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and not comply with them, and neglecting the METHODS TO AVOID HAZARDOUS SITUATIONS could
cause accidents resulting in serious or fatal personal injury and/or property damage.
WARNING
WARNING
WARNING
WARNING:
This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information go to www.P65Warnings.ca.gov.
S
AFE
TY
STAND
AR
D
CO
MPL
IES
ITH
W
ASME PASE-2019
