Brightness
Displays current light level for each channel.
Power On/Off
Turns unit on/off.
Dimmer
Allows user to set light level for each channel to compare colour combinations and light levels. Unit
returns to programmed setting on exit.
Timer
Sunrise
Sets time for sunrise.
Sunset
Sets time for sunset.
Sunlight
Sets light levels for sunlight.
Moonlight
Sets light levels for moonlight.
Preview
Runs through new settings.
System
System Time
Allows current date and time to be changed.
Wi-Fi Configuration
Allows change between one to one Wi-Fi connection and connection to Local Wi-Fi for connecting
multiple units.
Load default
Allows loading of default timer settings. SPS and LPS coral settings available.
Temperature
Displays chassis temperature and fan usage as a percentage.
Pilot Light
Turns On/Off pilot light.
Language
Allows language selection. English or Chinese.
Version
Displays latest version level of unit.
Fault Phenomenon
Cause Analysis
Solution
The screen
doesn’t display
The power plug is not properly inserted or the switch is not turned on.
Check the plug and turn on the switch.
Bad connection between unit and power supply.
Check connector.
Machine fault.
Contact Arcadia.
Buttons failure
There is foreign material on the buttons panel.
Remove the foreign material and keep the panel clean.
Machine fault.
Contact Arcadia.
The WIFI signal
cannot be found
The lamp WIFI is configured to Access Network Mode.
Reconfigure it to Hotspot Mode.
The device is too far away from the lamp or WLAN is not enabled.
Check the device WLAN and enable.
Machine fault.
Contact Arcadia.
APP cannot
control the lamp
The device is not connected to the lamp WIFI.
Reconnect to the lamp WIFI.
The network signal is bad or the lamp connection is disconnected.
Reconnect the lamp in the APP.
Machine fault.
Contact Arcadia.
The light doesn’t
operate according
to the timed set
brightness
The timing data set is not successfully saved.
Reset the data and save.
The time on the lamp is not correctly set.
Reset the time.
Machine fault.
Contact Arcadia.
Indicator Light
Meaning
The light is on but goes out after about 3 seconds.
The lamp WIFI works at Hotspot Mode.
Flicker for two times and go out for one time.
The lamp WIFI works at Access Network Mode, in the status waiting for configuration.
Flicker for three times and go out for one time.
The lamp WIFI works at Access Network Mode, and an error has occurred while connecting to a
home router, the reason may be that the password is wrong or the router is turned off.
Irregular flickering.
WIFI is transmitting data.
Goes out.
WIFI has no data transmitted.
UNIT INTERFACE
TROUBLE SHOOTING
FAULT DIAGNOSIS
