Make sure the lampholders are securely mounted before turning on the
luminaire.
Read and observe all the important notices on the appliance.
DO NOT SUBMERGE ANY PART OF THIS LUMINAIRE!
SAVE THESE INSTRUCTIONS
Lamp Installation
Your luminaire is not supplied with a lamp. We recommend that the relevant
wattage and colour Arcadia lamp is used. Please ensure that the correct
wattage lamp is used.
Unplug the luminaire before installing the lamp or lamps.
To install a lamp:
Unscrew the ring from each Ultra Seal lampholder.
Fit the rings onto each end of the lamp, an inert lubricant can be used to aid
assembly.
Align pins on lamp to the lampholder holes and insert the lamp by pushing
the lamp directly into the lampholder.
See illustration 2
Screw the rings tightly onto the lampholder body. Do not twist the lamp
within the lampholder.
See illustration 3
The ring is fully tightened when there is no gap between the ring and the body.
See illustration 4 / 5
Ensure that the ring is not cross-threaded.
See illustration 6
To remove the lamp, switch off and unplug the supply, undo the ring from
the lampholder body and pull the lamp directly out from the lampholder. Do
not twist the lamp in any way.
See illustration 7
Never use this Ultra Seal Electronic Controller without lamps in place.
NOT SUITABLE FOR USE WITH UVC LAMPS.
Physical Installation
Select a suitable site close to your electricity supply.
Place the controller on a firm surface and NOT on carpets or similar fabric
surfaces.
IT MUST NOT BE PLACED INSIDE AQUARIUMS
OR VIVARIUMS.
4
