ARC ACG4, User Manual

Page: 25 / 28

gas conversion
■ Take precautions on the operations and adjustments to be carried out when
converting from one gas to another.
■ All work must be carried out by a qualified technician.
■ Before you begin, turn off the gas and electricity supply to the appliance.
&KDQJHWKHLQMHFWRURIWKHEXUQHUV
1
5HPRYHWKHSDQVXSSRUW%XUQHUOLGDQG)ODPHVSUHDGHU
8QVFUHZWKHLQMHFWRUXVLQJDPPER[VSDQQHUDQGUHSODFHLWZLWK
WKHVWLSXODWHGLQMHFWRUIRUQHZJDVVXSSO\
&DUHIXOO\UHDVVHPEOHWKHDOOFRPSRQHQWV
$IWHULQMHFWRUVDUHUHSODFHGLWLVDGYLVDEOHWRVWURQJO\WLJKWHQWKH
injector in place.
2

Ž


Injector
Control handle
Tap
Sealing ring
■ Do not dismantle the tap shaft :
■ Before placing the burners
not blocked.
■ A full operational test and a test
(such as soap water or gas
a qualified technician or installer
has to mark “V” on the right gas
category to match with the
in rating plate.
Remove the previous
setting “V” mark.
in the event of a malfunction,
change the whole tap.
back on the top place, make sure
that the injector is
for possible leakages must be
carried out after gas conversion.
■ After completing conversion,
setting
detector)
Tuurn the taps down to minimum
R Remove the knob from the tap and place a small
‐
‐
‐
turning
does then remove the control knob and make further
from maximum flow to minimum flow. If it
Adjustmennt of minimum leevel of the flamee
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
/
must be tightly screwed in.
For butane propane gas, the adjusting screw
Refit the control knob.
ake sure that the flame does not go out by quickly M
adjustments to the gas flow, testing it again once the
adjustment has been made.
Repeat this process for each one of the gas taps.
2 4