- 29 -
Installation & Maintenance
4. Adjust the jumpers or use the connectors on the carrier board as described
in
3.2.1. Jumpers
on page
16
and
3.2.2. Connectors
on page
20
. Be
noted that the speakers and daughterboard are parts of ADK-712 module.
Refer to
1.5.2. Configure-to-Order Service on page 6
for details.
4.2. Install Hardware
The following sections will guide you through the basic hardware installation for
the computer. Remember to turn off the panel PC before installing/removing
inner hardware.
4.2.1. Install SSD or HDD
The computer supports a 2.5” HDD or SSD to work inside the computer. To
install a 2.5” HDD or SSD to the computer, slide a 2.5” HDD or SSD storage
device to the bracket. Fix them together by using four screws at the bracket’s
both sides. See the illustration below.
Summary of Contents for LYNC-712-4200G4 Series
