Arbor Technology FPC-3130, User Manual, Page: 49 / 86

- 39 -
Installation and Maintenance
2. Make sure JACC1 jumper is short for vehicle power mode
By default, JACC1 is short for FPC-3130V. Refer to 2.2.2. Jumper Setting
on page 12
.
3. Set System Automatic Power Mode
Use SW1 to set desired power mode. Refer to SW1 for FPC-3130V under
2.2.2. Jumper Setting on page 12
.
4. Set Battery Low Voltage Protection
Use SW2 to set battery low voltage protection. Refer to SW2 Setting of
2.2.2. Jumper Setting on page 12
.
3.7.2 Automation Power Mode for FPC-3130
1
. Automation DC Power Input Wiring
+ -
DC-IN
terminal block
captive
screw
Vcc
GND
Acc
2. Make sure JACC1 jumper is open to enable automation power mode
By default, JACC1 is open for FPC-3130. Refer to 2.2.2. Jumper Setting
on page 12
.
3. System Automatic Power ON/OFF
Use SW1 to set desired power mode. Refer to SW1 for FPC-3130 under
2.2.2. Jumper Setting on page 12
.
4. Battery Low Voltage Protection
Not Supported