11.2 Standard Command Set
107
11.2.11
Antenna System Delay Commands
Set System Delay
Command:
nnnnnnDA
nnnnnnDA sets the system delay compensation value. NOTE: Factory default setting for the standard 15
m (50 ft) cable is 60 ns plus 40 ns antenna group delay. Time range is from 0 to 999999 nanoseconds. The
exact syntax for a 100 ns delay is 100DA. See Section 4.4.1 for information on calculating cable delay.
Response:
C
11.2.12
Out-of-Lock Commands
Set Out-of-Lock Time
Command:
(-)nnK
(-)nnK configures the amount of delay time (in minutes) following loss of satellite synchronization before an
out-of-lock signal is generated and output via rear panel connector (if Option 93 is installed). A negative
number turns the out-of-lock function OFF. n = 0 sets the out-of-lock time to zero delay. n = 1 to 99 sets
the amount of delay time (in minutes).
Response:
C
11.2.13
Miscellaneous Commands
Return Firmware Version
Command:
V
V returns the firmware version date of the installed ROM.
Response:
dd mmm yyyy
C
Return Display Buffer
Command:
Z
Z returns the contents of Display Buffer.
Response:
Echoes current display (40 characters); no line wrap. For display contents, see Chapter 6,
Startup and Basic Operation.
Set Option Control
Command:
m,n,kXI
m,n,kXI configures the specified option board in the clock.
Where:
m = option selection number (see Table 11.5 below)
n = security key; 1201
k =
use only if m specifies Time and Frequency Monitor
. k = 0 for 60 Hz and k = 1 for 50 Hz.
Response:
C
Summary of Contents for 1201B
Page 4: ...iv ...
Page 153: ...B 7 Four Fiber Optic Outputs 135 Figure B 4 Jumper Locations ...
