Arbiter Systems 1088A, Operation Manual

Page: 105 / 279

9.2 Command Set 85
Position hold position information is set using the Set Position Hold RS-232 commands, the front-
panel Edit Position Hold function, or the Auto-Survey function.
9.2.8 Survey Mode Commands
Auto Survey Mode Selection
Command: m,nQ
m,nQ sets the mode (m) and number of fixes to average (n). Used to automatically determine
position data for Position–Hold. Requires Position–Hold mode to be ON to start the survey. See
conditions in Table 9.5. Use the SQ command during a survey to obtain the survey status. Activate
the Position–Hold mode with the PH1 command.
Response:
C
m Condition
0 Survey Off
1 Initiate single auto survey
2 Perform auto survey at power on
3 Temporarily suspend auto survey
4 Resume suspended auto survey
n Condition
0 Single Position
1 60 fixes (1 min.)
2 300 fixes (5 min.)
3 900 fixes (15 min.)
4 1800 fixes (30 min.)
5 3600 fixes (1 hour)
6 7200 fixes (2 hours)
7 14400 fixes (4 hours)
8 28800 fixes (8 hours)
9 43200 fixes (12 hours)
10 86400 fixes (24 hours)
Table 9.5: Auto Survey Setup Conditions