Arbiter Systems 1084A, Operation Manuals

Page: 59 / 256

6.7 Set Programmable Pulse Mode 39
6.7 Set Programmable Pulse Mode
Use the “Set Prog. Pulse” menu to set up one of the many pulse modes available for broadcasting
a pulse from P2 at a predetermined interval or rate (see Table 5.1 and Figure 5.1). Pulse modes
include Seconds per Pulse, Pulse per Hour, Pulse per Day, Single Trigger (pulse per year), Slow
Code and Pulse Polarity. Programming includes adjusting the pulse width, from a minimum of 10
milliseconds to 600 seconds, depending on the application, and configuring the pulse to occur at
either UTC or Local time.
RS-232C: see Section 9.2.10 .
Figure 6.9: Programmable Pulse Setup
6.7.1 Entering Numerical Values
When installing numerical values first use the UP/DOWN keys to change the digits and then use
the SETUP and ENTER keys to move the cursor left or right. Use the UP/DOWN keys as before
to change digits. To complete the installation after you have configured the numerical value, keep
pressing the ENTER key to move the cursor to the right and exit the menu.