User manual - Uniline Compact
10/2021
DOP_1363_A
8
The speakers are connected to the amplifiers via two 4-pin
SpeakonTM connectors on the back of each speaker:
1 + / 1- on LO section (low / medium)
2 + / 2- on HI section (medium / high)
In the vertical plane, the directivity index is progressive and
conditioned by the angular configuration of the system.
The speakers’ pivot axis is located on the same plane as the
exit groove of the APG ISOTOP
TM
waveguide.
This guarantees a continuous sound source, regardless of
angulation (tape type «line source»).
The UC206N and UC206W loudspeakers can be hung
within the same source line, their waveguides being strictly
identical and perfectly aligned. It is recommended to use the
UC206N loudspeakers for the upper part of the source line
and the UC206W for the lower part.
The SPL level and the coverage are therefore fully configu-
rable to best suit the geometry of the audience area, simply
by a judicious choice of speakers and angles between the
speakers that make up the system.
AFMG EASE Focus 3 software can simulate all APG systems
and determine the correct configuration for each application.
The APG UC206N and UC206W loudspeakers are equipped
with 4 handles (2 side and two rear). Two lugs designed to
accommodate carabiners are available at the rear of the en-
closure, allowing the horizontal angle to be maintained when
hanging from 1 motor point.
1+
1+
2-
2-
2+
2+
1-
1-
Carabiner clip / Halliard
