ARB 3444070 Fitting Instructions Download Page 1

 

27/10/05 

Page 1 of 4 

3782586

 

ARB WINCH BULL BAR TO SUIT 
HOLDEN JACKAROO STD, SE & MONTEREY 1998-2001 
HOLDEN JACKAROO STD 2001 ON 

No 3444060 

ARB WINCH BULL BAR TO SUIT 
HOLDEN JACKAROO WIDE BODY SE & MONTEREY 2001 ON 

  No 3444070 

 
 

 

WARNING 

FOR VEHICLES EQUIPPED WITH SRS AIRBAG 

WHEN INSTALLED IN ACCORDANCE WITH THESE INSTRUCTIONS, THE FRONT 

PROTECTION BAR DOES NOT AFFECT OPERATION OF THE SRS AIRBAG. 

 

TAKE NOTE OF THE FOLLOWING: 

 

 

THIS PRODUCT MUST BE INSTALLED EXACTLY AS PER THESE INSTRUCTIONS USING ONLY THE 

HARDWARE SUPPLIED. 

 

 

DO NOT USE THIS PRODUCT FOR ANY VEHICLE MAKE OR MODEL, OTHER THAN THOSE SPECIFIED 

BY ARB. 

 

 

DO NOT REMOVE LABELS FROM THIS BULL BAR. 

 

 

THIS PRODUCT OR ITS FIXING MUST NOT BE MODIFIED IN ANY WAY. 

 

Summary of Contents for 3444070

Page 1: ...D WITH SRS AIRBAG WHEN INSTALLED IN ACCORDANCE WITH THESE INSTRUCTIONS THE FRONT PROTECTION BAR DOES NOT AFFECT OPERATION OF THE SRS AIRBAG TAKE NOTE OF THE FOLLOWING THIS PRODUCT MUST BE INSTALLED EXACTLY AS PER THESE INSTRUCTIONS USING ONLY THE HARDWARE SUPPLIED DO NOT USE THIS PRODUCT FOR ANY VEHICLE MAKE OR MODEL OTHER THAN THOSE SPECIFIED BY ARB DO NOT REMOVE LABELS FROM THIS BULL BAR THIS PR...

Page 2: ...72 2 M6 X 20OD FLAT WASHER 6151128 2 M6 FLANGE NUT NUMBER PLATE TO BAR 6151017 2 M6 X 16mm BOLT 6151128 2 M6 FLANGE NUT 4581035 4 M6 X 16OD FLAT WASHER WINCH TO BAR 4581040 4 M10 FLAT WASHER 3500080 1 ARB INDICATOR KIT 180302 4 CABLE TIES 3500200 1 BUFFER KIT TOOLS REQUIRED Basic tool kit drill 10mm and 12mm drill bits FITTING THE 9 000lb WINCH 1 Place the bull bar on a suitable stand 2 To place t...

Page 3: ...trol box to the control box bracket using the two 1 4 nuts flat washers and spring washers supplied in Warn kit Centralise the control box in the cut out then tighten nuts firmly 6 Fit the control box bracket to the bull bar using two M6 x 20mm dome head bolts flat washers and flange nuts 7 Fit the winch and roller fairlead into the bull bar using bolts from the winch kit and four M10 washers from...

Page 4: ...e nuts supplied 13 Lift the bull bar between the chassis bracket and bolt up using the M12 x 30mm bolts flat washers spring washers and nuts Align the bar horizontally and vertically Make sure there is a gap between 20 and 25mm between the bull bar and the vehicle grill and guards 14 When correctly aligned tighten all the bolts firmly 15 Drill and pin using the M10 x 25mm bolts flat washers spring...

Reviews: