1.2. Mounting Extrusion and Ladder - Attachment Instructions
1. Remove mounting extrusion from the carton (cut as per Diagram 1 if you intend opening the
rooftop tent off the rear of your vehicle.)
2. Place the tent on its side on the ground onto a clean surface.
3. Using the supplied 8mm x 40mm bolts and large washers, slide your hand in between the inside of
the base and the mattress and insert the bolts into the pre-drilled holes. See Diagram 2.
4. Place the mounting extrusion into position over the bolts.
5. Slide the 8mm nuts into the mounting extrusions and tighten the bolts from inside the tent. See
Diagram 2.
6. Near the outside edges of the mounting extrusion you will find holes for the self drilling screws
supplied. Use the self drilling screws to attach the outside edge of the mounting extrusion to the
base of the tent through the pre-drilled holes. on the outer most edge of the extrusion.
7. Mount the Ladder brackets to the ladder using the supplied 6mm x 20mm bolts, washers, plastic
washer and nut. See Figure 1.
8. Mount the ladder to the base of the tent using the 4 x 6mm x 45mm bolts. Bolt each ladder bracket
to the base of the tent through the pre-drilled holes. See Figure 2.
8mm x 40mm bolt
large washer
aluminium mounting extrusion
8mm nyloc nut
slide plate with
8mm x 55mm bolt
roof rack or roof bars
tent base
The mounting extrusion fitted to the base of the tent with the
slide plate and bolt fitted.
Diagram 2
PAGE 4
Figure 1
Nut
Plastic
washer
Ladder
Mount
Bracket
Washer
Bolt
(6mm x 20mm)
Figure 2
Washer
