Version 1.0 – Søren Due – 30.11.2017
page 1/4
GSM2ACCESS V4
Manual
Version
Change
Author
1.0
First version
Søren Due
Page 1: ...Version 1 0 Søren Due 30 11 2017 page 1 4 GSM2ACCESS V4 Manual Version Change Author 1 0 First version Søren Due ...
Page 2: ...ng call Disassembling the unit To take the unit apart to attach wires SIM card SD card and setup functionality on the Dip Switches 4 screws is removed This can be done in either end of the unit but its recommended to do this in the end where the wires goes into the unit The complete board can then easily be removed from the casing Board Layout Inside the unit there is a terminal block for connecti...
Page 3: ...ly s ground to make sure the Wiegand signals work correctly DIP Switch Switch ON OFF 3 4bit Bust for keypress 8bit burst for keypress 2 32bit Wiegand Output 50bit Wiegand Output 1 Listening mode ON Listening mode OFF Listening mode OFF When the unit receives a call it hangs up the call and sends the incoming phone number on the Wiegand bus Listening mode ON When Listening mode is ON the call will ...
Page 4: ...essage No IN0 or IN1 signal SIM Card To inset the SIM card push the Micro SIM into the SIM Slot Please note that the SIM card must be configured without PIN control and voice mail must be removed deactivated To remove the SIM again push the SIM card in gentle until you hear a click and the SIM will automatically be pushed out so it can be removed Please look at the Board Layout that shows witch wa...
