ARAG DELTA 80, Installation, Use And Maintenance Manual

Page: 105 / 126

105
"JOB MENU" - F8 MENU
15.8
F8
Menu
Job settings menu
1
2
Fig. 336
1
In the guidance screen, press
Menu
.
2 Press
F8
to view the
Settings menu
(Fig. 337).
Fig. 337
In this screen it is possible to access
several different menus, which can be
useful during spraying:
•
Alarms
(par. 10.1.11).
•
Working parameters
(par. 10.1.12).
•
Speed source
(par. 15.8.1).
•
User
(par. 10.6).
•
Device status
(par. 10.8).
15.8.1 Speed source
Fig. 338
Allows to select the source for speed calculation. Available options:
• GPS
Information concerning speed is received by the GPS, which is connected directly to Delta 80.
• Wheel sensor
When this option is enabled, the speed is calculated on the basis of the pulses received by the
speed sensor installed on the wheel.
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
The wheel constant must be entered during the setup procedure (par. 10.1.8).
• GPS and Wheel sensor
When this option is enabled, Delta 80 uses both sources:
- the guidance information and the accessory functions are active thanks to the data sent by the
GPS receiver;
- the output is adjusted (par. 13.1) according to the speed read by the wheel sensor.
• Simulation
Allows to enable speed simulation in order to carry out adjustment tests even when the machine is stationary.
SIMULATION
SPEED
Fig. 339
Edit simulation speed (DEF 6.0 km/h - 3.7 MPH) :
F3
(
+
) increases,
F5
(
-
) decreases
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
Par.
7.4
Confirm access
or data change Exit the function or
data change
Delete
selected
character
Scroll
(LEFT /
RIGHT)
Data
increase /
decrease
Scroll
(UP /
DOWN)
Enter
selected
character