VP5000-DC/DC60, VP5000-DC/DC200-HL
About the manual
Last edited 2019-02-08
by Sonja Scheunert
Filename
VP5000_DCDC60_200-HL_installation_manual_v1-4en.docx
9 / 173
Use of square and pointed brackets
If information refers to the connections on the VECTOPOWER, the names of the connections are
written in square brackets: e.g., DC link DC+ and DC- = [DC+/-]; output and OUTPUT- =
[/-], as well as the logical connections [ST1], [ST2] ... The names of the connections are
written as they are labeled on the device. If a statement concerns both polarities, + and - are given
together in square brackets, for example [DC+/-]. If a statement only concerns one polarity,
however, only the corresponding polarity is indicated in square brackets, for example, [DC-].
If the names of menu items, buttons, etc. in the VEConfig software are mentioned, they are written
in pointed brackets, for example, <File>, <Exit> ....
Applicable standards and directives
1.7
Designation
Title
EN 62477-1
Safety requirements for power electronic
converter systems and equipment - Part 1:
General
Table 3: Applicable standards and directives
Copyright, brand names
1.8
Copyright ©ARADEX AG.
This document is protected by copyright. Any reproduction, processing, distribution, or other
utilization of this installation manual – even in part – is prohibited without the written permission of
ARADEX AG.
All figures are from ARADEX AG if no other source is indicated in the caption.
VECTOPOWER,
VECTONUM Embedded, VECTODRIVE, VECTOBUS, VECTONET, and VECTOVISION
are registered trademarks of ARADEX AG.
In this manual, other trademarks and designations may be mentioned that are registered and
licensed trademarks of other companies. These are not specially marked. Their use by third parties
may infringe upon the rights of their owners.
