PLEASE NOTE : Image shows Ecoburn S3, however procedure is the same
regardless of appliance model.
Applicable Part Numbers — LOG-xxx
STAND-xxx
FEET-xxx
(NOTE: xxx-Model insignia)
Applicable for the following appliances :
Holborn, Ecoburn S3 & M-Series
WARNING : HEALTH & SAFETY
Please ensure the appliance is cold and unlit before commencing fitting this accessory kit.
Please refer to the main instruction booklet, relevant to your stove, for guidance on the
installation and operation of the appliance.
Arada Ltd will not be responsible for any consequential or incidental loss or injury however caused.
Please note, this accessory kit can only be fitted
prior
to the appliance (stove) being installed and
connected to the flue system, within the property.
Please consult Health & Safety guidelines for advice on handling heavy and / or large items. When
lifting, we recommend you always obtain assistance
When handling the components of the kit, it is recommended to wear suitable gloves to prevent
hand injuries.
1. Fitting Instructions :
Depending upon your appliance model, your stove may have been factory fitted with the standard
foot assembly, however if so desired, this can be removed and an optional stand or log store can be
fitted, so that the appliance height can be raised.
STEP 1: (NOT Applicable To M-Series)
To remove the factory fitted feet assembly, it is suggested that the canopy assembly be removed to
avoid damage. Carefully lower the stove onto its rear, taking care not to damage the rear air box
and tertiary air inlet cover. We recommend lowering the stove onto the packing pallet that it was
delivered on, as shown below.
STAND & LOG STORE FITTING GUIDE
Page 2
BK 748
