background image

8. Remove the darthead hub from the motor case. 

Make sure to detach the phone cable from the 
smart target board inside the hub first.

9. Feed the axle shaft through the drape opening.
10.Replace the darthead hub and secure tightly to 

the shaft.

11. Slide the other 69” metal pole through one side 

of the drape and through the base.

12.Install the display on the top center of the game. Make sure that 

it is in the center of the graphic. 

13.Install the lamps onto the top of the frame. Plug their power cords

into the outlet provided on the outside of the motor case.

14.Raise the drape support through the second set of holes so that 

it rests on the spring buttons.

1. Locate the darthead arms.
2. Open the darthead hub. The guides have an alignment pin 

on the lower end of them. 

3. Loosen the socket head screws holding the clamp bar in 

the darthead hub. 

4. Insert the darthead arm, carefully feeding the wires and 

connectors through first. Slide it all the way in until it hits the
alignment pin. Lock in place using the clamp bar. 

5  Repeat steps 3 and 4 for all four darthead arms.

Installing the Dartheads

6. Plug the black connector at the end of each darthead arm 

in to the smart target board. 

These connectors are keyed 

and can only go in one way

. The order of the connections 

does not matter.

Caution: If you put the connectors in backwards, and push 
too hard, you may bend the pins on the Smart Target Board.

7. Close darthead hub when finished.
8. Attach the number rings to each darthead making sure to 

align the number 3 so that it is over the darthead arm.

Reviews: